Home > Residential Services > Tune Ups Maintenance

Heating & Air Conditioning Maintenance Services in Southeastern Wisconsin

Annual maintenance of your furnace or air conditioning unit is the key to its long life and to energy efficiency.

 

Did you know...

Dirt, dust and other build up are the #1 reason for repair calls – but, they are also the most preventable!

Annual tune ups eliminate breakdowns due to neglect AND:

  • Reduce your energy bill by maintaining efficiency
  • Prolong the unit’s life
  • Catch other malfunctions before they occur
  • Ensure unit is operating safely

Our tune ups include a complete cleaning and all the checks and tests necessary to ensure your unit is operating safely and efficiently.

We base our tune up checklist on the recommendations set forth by the Air Conditioning Contractors of America. 

 

 

Oil Furnace Tune Ups

 

 

Air Conditioner
Tune Up Checklist

 

 

 

  • Checked thermostat and made adjustments where necessary
  • Tightened all electrical connections
  • Inspected low and high volt wiring
  • Oiled condenser fan motor
  • Tested safety controls
  • Cleaned evaporator drain
  • Cleaned rubbish out of condenser and cleaned with coil cleaner
  • Checked refrigerant level and advised leak detection if necessary
  • Cleaned and adjusted blower components
  • Checked indoor evaporator temp drop
  • Inspected and adjusted belts
  • Adjusted humidifier dampers
  • Measured evaporator super heat
  • Tightened all refrigerant valve caps
  • Checked and replaced filter with consent if necessary
  • Resealed outside line set penetration if necessary
  • Analyzed unit’s operation and appearance and informed of its efficiency, condition and any necessary recommendations
     

 

 

Gas Boiler Tune Up

 

 

 

Gas Furnace
Tune Up Checklist

 

 

  • Checked thermostat and made adjustments where necessary
  • Tested safety controls
  • Removed rust and soot and cleaned and adjusted burners
  • Cleaned and adjusted ignition assembly or OHM igniter
  • Checked micro and signal from flame sensor
  • Adjusted gas/air mixture for optimum efficiency
  • Oiled motor bearings
  • Cleaned condensate trap
  • Checked all gas connections located in unit
  • Adjusted gas/pilot pressure
  • Inspected and adjusted belts
  • Checked filter and replaced with consent if necessary
  • Checked and tightened all exhaust pipe connections
  • Clean and adjusted fan timer
  • Inspected and cleaned heat exchanger thoroughly
  • Ensured correct temperature rise
  • Checked electrical wiring and tightened all electrical connections
  • Cycled unit and made adjustments accordingly
  • Inspected blower access door and ensured correct operation
  • Analyzed unit’s operation and appearance and informed of its efficiency, condition and any necessary recommendations.

 

 

Oil Furnace Tune Up

 

 

 

Oil Furnace
Tune Up Checklist

 

 

 

  • Checked thermostat and made adjustments where necessary
  • Tested safety controls
  • Removed rust and soot and cleaned and adjusted burners
  • Replaced oil filter
  • Replaced nozzle and adjusted electrodes
  • Adjusted gas/air mixture for optimum efficiency
  • Oiled motor bearings
  • Cleaned condensate trap in high efficiency units
  • Adjusted barometric damper
  • Checked transformer
  • Inspected and adjusted belts
  • Checked filter and replaced with consent if necessary
  • Checked and tightened all exhaust pipe connections
  • Clean and adjusted fan timer
  • Inspected and cleaned heat exchanger thoroughly
  • Ensured correct temperature rise
  • Checked electrical wiring and tightened all electrical connections
  • Cycled unit and made adjustments accordingly
  • Inspected blower access door and ensured correct operation
  • Checked CO level of exhaust
  • Checked fire pot, comb. air wheel and pump coupling
  • Checked all oil connnections in unit
  • Analyzed unit’s operation and appearance and informed of its efficiency, condition and any necessary recommendations.


Gas Boiler Tune Up

 

 

 

Gas Boiler
Tune Up Checklist

 

 

 

  • Checked thermostat and made adjustments where necessary
  • Drained expansion tank if unit has isolation valves
  • Tested flue damper operation
  • Checked/adjusted temp and pressure settings
  • Tested safety controls
  • Removed rust and soot and cleaned and adjusted burners and exchanger
  • Cleaned and adjusted ignition assembly or OHM igniter
  • Checked micro amp signal from flame sensor
  • Adjusted gas/air mixture for optimum efficiency
  • Oiled motor bearings
  • Cleaned condensate trap if high efficiency boiler
  • Checked CO level of exhaust
  • Checked and tightened all exhaust pipe connections
  • Checked all gas connections located in unit
  • Adjusted gas/pilot pressure
  • Inspected and cleaned heat exchanger thoroughly
  • Checked electrical wiring and tightened all electrical connections
  • Cycled unit and made adjustments accordingly
  • Analyzed unit’s operation and appearance and informed of its efficiency, condition and any necessary recommendations.

 

Oil Boiler Tune Up

 

 

 

Oil Boiler
Tune Up Checklist

 

 

 

  • Checked thermostat and made adjustments where necessary
  • Drained expansion tank if unit has isolation valves
  • Tested flue damper operation
  • Checked/adjusted temp and pressure settings
  • Tested safety controls
  • Removed rust and soot and cleaned and adjusted burners and exchanger
  • Adjusted gas/air mixture for optimum efficiency
  • Oiled motor bearings
  • Cleaned condensate trap if high efficiency boiler
  • Checked CO level of exhaust
  • Checked and tightened all exhaust pipe connections
  • Inspected and cleaned heat exchanger thoroughly
  • Checked electrical wiring and tightened all electrical connections
  • Cycled unit and made adjustments accordingly
  • Replaced oil filter
  • Replaced nozzle and adjusted electrodes
  • Adjusted barometric damper
  • Checked transformer
  • Checked fire pot, comb. air wheel, and pump coupling
  • Checked all oil connections in unit
  • Analyzed unit’s operation and appearance and informed of its efficiency, condition and any necessary recommendations.

$134.90   Air Conditioner 

$134.90   Gas Furnace

$159.90   Gas Boiler
$239.90   High Eff. Gas Boiler

$264.90   Oil Furnace/Boiler

(Includes nozzle and filter) 

All prices are for residential homes


After your tune up has been completed, our technician will go over what was performed, give you a checklist to keep for your records and give you his honest opinion of your system.

We will always make time to answer any questions you might have.

 

 

Your Furnace is Like
the Body's Heart

Your furnace and air conditioner can be compared to your body's heart. Your heart cannot run when it is clogged - same goes for your heating & cooling equipment.

The grass, dirt, dust and filth in the pictures below were restricting the unit's performance - causing higher energy bills, yet delivering less cooling. Cleaning the unit has enabled optimum performance!

 

Before

Dirty Furnace

 

After

Cleaned Furnace

 

Before

Before Uncleaned AC unit

 

After

AC Unit after Cleaning

 

Before

Before Uncleaned AC Fan

 

After

After Cleaned AC Fan

 

Before

Before Uncleaned AC Part

 

After

After Uncleaned AC Part